Why is my LG DHB1260PL not removing enough moisture?
If your LG Dehumidifier isn't removing much moisture, it could be due to several factors: * The air filter might be clogged, or it may be time to replace it (after about 5 months of use). * The unit may be set to Air Purifying mode. * The room's temperature and humidity might be low. * The air inlet or outlet could be blocked.
General| Brand | LG |
|---|---|
| Model | DHB1260PL |
| Category | Dehumidifier |
| Language | English |
Warnings and cautions regarding safe use of the power cord and electrical connections.
Precautions against injury from moving parts and inserting objects into the unit.
Explanations for warning and prohibition symbols used in the manual.
Identifies and describes components located on the front of the dehumidifier.
Identifies and describes components located on the rear of the dehumidifier.
Explains the buttons, indicators, and modes of the control panel.
Details the meaning of different indicator lamps on the control panel.
Specifies operating temperature, ventilation, and initial setup steps.
Guides on connecting power, turning on, setting humidity, and mode conversion.
Instructions on using the Louver and Auto Swing button for airflow control.
How to turn off the unit using the ON/OFF button.
Details automatic dehumidification for clean air and humidity control.
Explains the quiet operation mode with low fan speed.
Describes mode to prevent dew in low room temperatures.
Explains air purifying mode for cleaning contaminated air.
Steps for using the hose to direct dried air for targeted drying.
How to press the Spot Dry button and what happens next.
Guidance on using an extension hose and related warnings.
How to use the unit for non-stop laundry drying.
How to adjust airflow direction using the Louver and Auto Swing button.
Explains the automatic defrosting process and related indicators.
Describes what happens when the water bucket is full and the indicator light.
Instructions on setting and cancelling the timer function.
How to set the desired humidity level for automatic operation.
Steps for removing the bucket, pouring water, and wiping it dry.
Ensures the bucket is correctly positioned for the unit to operate.
Important cautions for handling the bucket and cleaning the unit.
Warnings and conditions for using the continuous drainage feature.
Steps for connecting the hose to the continuous drainage hole.
Instructions on how to safely move the dehumidifier using its caster.
Instructions for cleaning the air filter every two weeks.
Guidance on handling the deodorizing filter and its replacement.
Steps to correctly install the air filter after cleaning or replacement.
Steps to unplug, remove water, and clean the filter before storage.
How to dry and store the filter properly for long-term storage.
Checks for issues when the operation buttons are pressed but the unit doesn't start.
Reasons for small amounts of moisture being removed, like clogged filters or wrong modes.
Explains why the unit might not be drying air effectively, like open windows or large areas.
Notes that humidity readings may differ based on location.
Possible causes for fan noise, such as unstable floor or clogged filter.
Reasons why laundry may not be drying properly, like poor air contact or too much laundry.
Explains when operation repeats alternately, possibly due to AUTO mode.
Potential causes for water leaks, such as unit skewing or hose connection issues.
Explains compressor delay and auto-shutoff when humidity is met.
Describes noise increase when the compressor starts or in AUTO mode.
Notes that noise volume changes with Louver angle.
Mentions sounds from coolant circulation stabilization.
Explains temporary smell due to heat exchanger temperature increase.
Clarifies that warm wind is normal as there's no cooling function.
Suggests pressing AUTO Swing button again for abnormal Louver operation.
Explains that factory test water or evaporation traces in the bucket are normal.
To Next Page
