41
WARNING !
When you disassemble the lamp connector,
be sure to disconnect the dryer from its electrical
supply. Protect your hands and arms from sharp
edges when working. To reduce the risk of Injury to
persons adhere to all industry recommended safety
procedures including the use of long sleeved gloves
and safety glasses.
Disconnect the door lamp and electrode sensor connector.
Remove 4 screws.
the front bulkhead.
Remove the control panel.
Hold the light in place while the base of the
light on both sides.
Replace the light with a new light.
TUB DRUM [FRONT]
DRUM ASSEMBLY
CHANGING THE DRUM LIGHT
To Next Page
Loading...
Need help?
General
