2-2.
Reconnect the another duct [11 in (28cm)] to
the blower housing, and attach the duct to the
base. (Duct is a SVC part)
2-1.
Detach and remove a knockout at the botton,
left or right side as desired. (Right Side Vent not
available on Gas dryer)
, , the order of work.
3-1.
Pre-assemble 4" elbow with 4" duct.
Wrap duct tape around joint.
3-2.
Insert the elbow duct assembly through the side
opening and connect the elbow to the internal
duct.
To Next Page
Loading...
