EasyManuals Logo

LG DLGX4001B User Manual

LG DLGX4001B
63 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #32 background imageLoading...
Page #32 background image
32 INSTALLATION
Restricted or Blocked Airflow
Avoid long runs or runs with multiple elbows or
bends.
Excess or crushed
transition duct
Too many elbows or
exhaust too long
Check for blockages and lint buildup.
Lint buildup or blockage
Make sure the ductwork is not crushed or restricted.
Crushed or damaged
exhaust
Check the Duct Condition
If the Flow Sense™ Display is turned on, check the
exhaust system for restrictions and damage. Repair
or replace the exhaust system as needed.
NOTE
When the dryer is first installed, this test should be
performed to alert you to any existing problems with
the exhaust duct in your home. However, since the
test performed during normal operation provides
more accurate information on the condition of the
exhaust duct than the installation test, the number
of bars displayed during the two tests may not be
the same.
Do not interrupt the test cycle, as this could result in
inaccurate results.
Even if the Flow Sense display does not light up
during the test cycle, some restrictions may still be
present in the exhaust system. Refer to the Venting
the Dryer section of this manual for complete
exhaust system and venting requirements.
Error Codes
Check the error code before you call for service.
Error
Code
Possible
Causes
Solutions
tE1 or
tE2
Temperature
sensor failure.
Turn off the dryer and call
for service.
HS
Humidity sensor
failure.
Turn off the dryer and call
for service.
PS,
PF, or
nP
Electric dryer
power cord is
not connected
correctly, or
house power
supply is
incorrect.
Check the power supply
or the connection of
the power cord to the
terminal block. Refer to
the Connecting Electric
Dryers section of this
manual for complete
instructions.
House fuse is
blown, circuit
breaker has
tripped, or
power outage
has occurred.
Reset circuit breaker
or replace fuse. Do
not increase the fuse
capacity.
If the problem is a
circuit overload, have it
corrected by a qualified
electrician.
gAS
Gas supply or
service turned
off. (Gas Model
only.)
Confirm that house gas
shutoff and the dryer
gas shutoff are both fully
open.

Other manuals for LG DLGX4001B

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the LG DLGX4001B and is the answer not in the manual?

LG DLGX4001B Specifications

General IconGeneral
Typefront load; gas
Colorblack steel; white (w), black steel (b)
Dryer Capactity7.4 cu. ft.
Number of Cycles12
Number of Options12; more time, less time, damp dry signal, wrinkle care, control lock, wi-fi, energy saver, turbosteam™, reduce static, remote start, drum light, signal
Drying Levelsvery dry, more dry, normal dry, less dry, damp dry
Ventingvented; electric: 4 way venting / gas: 3 way venting
Temperature Settingshigh, med.high, medium, low, ultra low; 5
Control Paneldigital and knobs
Cycle Signalyes
Interior Lightyes
Drying Rackno
Sensor Dry Optionyes
Sanitize Optionyes
Steamturbosteam™; yes
Smart Homeyes
Remote Controlyes
Wi-Fiyes
Voltage120 volts
Current15
Weight and Dimensions IconWeight and Dimensions
Depth30 1/8 inch
Height39 inch
Width27 inch
Net Weight139.3 lbs

Related product manuals