10
Checking connection status with the LED colour
You can check the connection status with the LED on the front of the wireless receiver.
LED Colour Status
Blinking green Connecting In progress
Green Connected successfully
Red Bad connection, or the receiver is in standby
Off Power cable not connected
Manual connection
If you see a red LED on the front of the wireless receiver, it means that the sound bar is not connected to the
receiver. If this is the case, connect them in the following order.
a Press the Power
button on the sound bar to turn it off.
b Press the PAIRING button on the back of the wireless receiver. Check if the LED on the front of the wireless
receiver is blinking green.
c Press the Power button on the sound bar to turn it on.
d When the connection is established, you will see the LED light on the front of the wireless receiver light up
green.
Note
• Keep the rear speakers at least 30 cm away from the TV or monitor.
• To prevent wireless interference, maintain a distance of at least 1 m between the sound bar or the wireless
receiver and any peripheral devices that generate strong electromagnetic waves (ex. wireless routers,
microwave ovens, etc.).
To Next Page
Loading...
Need help?
General
Weight and Dimensions
