35
OPERATION
ENGLISH
3
Press the
Delay End
button as necessary.
4
Press the
Start/Pause
button.
• Except for LED of the
Delay End
button, all LEDs
on the control panel will be turned off within 20
minutes. This feature may vary depending on
the model purchased.
• The delay time is the time to the end of the
programme, not the start. The actual running
time may vary due to water temperature, clothes
and other factors.
• To cancel the function, the
Power
button should
be pressed.
• Avoid using liquid detergent for this function.
Using the ezDispense
Use the
Dispenser 1
and
Dispenser 2
buttons to
set up and control the
ezDispense
function.
a
Dispenser 1
button
b
Dispenser 2
button
c
Buttons indicator
d
Liquid detergent indicator
e
Link indicator (Using only liquid detergent both
compartments)
f
Buttons indicator
g
Liquid fabric softener indicator
• Whether the detergent or softener indicator may
blink and the chime may sound, even if there is
sufficient detergent or softener left to use for
approximately 2 to 4 washing programmes;
- If the liquid detergent indicator
d
and
buttons indicator
c
,
f
blink and the chime
sounds, pour the detergent into the
compartment, up to the
MAX
line.
- If the liquid fabric softener indicator
g
and
buttons indicator
f
blink and the chime
sounds, pour the fabric softener into the
compartment, up to the
MAX
line.
• The default settings are configured to dispense
the detergent of
Dispenser 1
and the fabric
softener of
Dispenser 2
.
Changing Dispense Level for a Single
Load
1
Press the
Power
button.
2
Turn the knob to select the desired cycle.
3
Press the
Dispenser 1
or
Dispenser 2
button
to increase or decrease the dispensed amount
from the set defaults.
Buttons Indicator
Dispensed Amount
*1
More (110%)
Medium (100%)
Less (90%)
To Next Page
Loading...
Need help?
General
