DISASSEMBLY
- 8 -
1. Put a soft cushion on the floor and lay the stand on its
side so that the base is accessible.
4. Cover the panel with your hand so that it is not scratched.
Then, pull up the cabinet corner side.
5-1. Disassemble the cabinet.
5-2. Hold the control PCB as shown in the figure and gently
pull it out.
6. Push up the back cover as shown in the figure and pull
out the chassis assembly so that the latch is untied.
2. Hold the set while folding the latch and take out the stand
base.
3-1. Push the cover upward and remove it.
3-2. Unscrew the four screws.
# 1 # 4
# 2 # 5
# 3 # 6
To Next Page
Loading...
