LG GB210 - Procedure

- 108 -
LGE Internal Use Only Copyright © 2009 LG Electronics. Inc. All right reserved.
Only for training and service purposes
11. AUTO CALIBRATION
1. Connect as Fig 6-2(RS232 serial cable is connected between COM port of PC and MON port of TEST JIG, in
general)
2. Set the Power Supply 4.0V
3. Set the 3
rd
, 4
th
of DIP SW ON state always
4. Press the Phone power key, if the Remote ON is used, 1
st
ON state
11.4 Procedure
1. Connect as Fig 11.2.2 (RS232 serial cable is connected between COM port of PC and
MON port of TEST JIG, in general.)
2. Run
Hot_Kimchi.exe to start calibration.
3. From the Calibration menu, Select GB210!
(3)