9
Installation
Electrical connection
This appliance should be connected to the mains AC
220~240V , 50 Hz. You must connect this appliance only
to the power socket with grounding complying with the
related regulations and only an approved expert should
install this appliance.
Starting
Before switching it on, leave the appliance standing for
at least 2 hours, so that the circulation of the refrigerant
stabilizes and no operating problems occur.
Operation
°C
h
When the appliance powers on, the initial state displayed
on LED is "-18°C".
Button K1 (Defrost):
Press butoon K1 for the first time, indicator "-", "°C", "h"
shut off, compressor stop running and the value displayed
on LED is"OF". Press button K1 for the second time, indicator
"-", "°C", "h" display normally, compressor running
normally and LED displays the initial state.
Button K2 (Quick freezing):
Press butoon K2 for the first time, indicator "-", "°C"shut off,
indicator "h" light on and initial freezing time displayed is"3h".
Press button K2 for the second time the freezing time displayed
is "2h". Press button K2 for the third time the freezing time
displayed is "1h". The compressor will ren from 1hour to
3 hours according to the freezing time displayed on LED.
Press button K2 for the fourth time, the indicators will recover
the state before quick freeze.
Button K3 (Temperature regulation):
Press button K3 continuously, the provided temperature
displayed will be from -14°C to -24°C circularly.
Downloaded from Fridge-Manual.com Manuals
To Next Page
Loading...
Need help?
General
