LG GC-L257SQSL User Manual

41
MAINTENANCE
ENGLISH
4 Tighten the screw cap until the colored line in
the water filter is no longer visible.
5 Press and hold the Water Filter button for
three seconds. That resets the
Replacement
Filter
icon. The new water filter has been
activated.
6 Dispense water for approximately 5 minutes to
remove trapped air and contaminants from the
system.
Push fit connector type
*1
1 Remove the screw cap.
2 Pull the pipe out from the water fitler.
3 Push the pipe into the water fitler, making sure
the end is fully sealed.
4 Insert the screw cap until the colored line in the
water filter is no longer visible.
5 Press and hold the Water Filter button for
three seconds. That resets the
Replacement
Filter
icon. The new water filter has been
activated.
6 Dispense water for approximately 5 minutes to
remove trapped air and contaminants from the
system.
CAUTION
• Failure to replace filters when required or using
non LG authorised water filters can cause the
filter cartridge to leak and result in property
damage.
Application Guidelines/Water
Supply Parameters
• Service Flow: 1,9 lpm
• Water Supply: Community or Private Well -
Potable Water
• Water Pressure: 138 - 827 kPa
• Water Temperature: 0,6 - 37,8 °C
• Capacity: 1 892 litres
Deodorizer
Reusing the Deodorizer
You can re-use the deodorizer by removing odors
from the deodorizer.

LG GC-L257SQSL Specifications

General

Brand	LG
Model	GC-L257SQSL
Category	Refrigerator
Language	English