PROGRAMMING MODE
2. Factory reset - EEPt
After a factory reset, all values are reset to the default values.
Entering set up
mode.
You will see LqC1
Button Display
Press the Med Temp. or the Low Temp. Button until
appears in the display.
Press the Start button.
Press the Med Temp. button until appears in the
display.
Press the Start button, then factory reset is done.
is displayed.
1. Continue to set up the next mode.
2. Stop the change of setup value and go back to ready mode.
• Coin type - Turn on/o toggle switch.
• Card type - Pull the service card.
• Stack type - 1. Control panel open.
2. Turn on/o toggle switch.
• OPL type - Push “High Temp.” + “Low Temp.” and the ‘3’.
• Dryer default value
- Drying time 45 Minute
- Top off time 15 Minute
• Drying time in OPL machine can be changed from 10 to 100 Minutes by pressing the cycle button.
NOTE
To Next Page
Loading...
Need help?
General
