19
4.
Move the position of Hinge-U pin
, and
Cap, Top cover
Assemble the Fridge
Door
Assemble Hinge-C
and bolt
Assemble F-Door . Assemble the Hinge-L
and bolt
. Assemble Low Cover
and screw
.
5.
Install HANDLES
installed at the existing
freezer room, at the refrigerator room.
Adjust the bottom part of HANDLES to the
groove and then fasten 2 screws
after
removing the CAP . After bolting
SCREWS in the side of the refrigerator
room DOOR, press and insert the CAP
.
Insert the CAP
to hole which the
HANDLE
was installed previous.
The freezer room HANDLES
are
assembled in the same manner as above
using the existing.
6.
Stop the groom where the existing
HANDLE
,
was installed at by using
the CAP removed in the initial
installation.
Note
Reversing the doors is not
covered by the warranty.
To Next Page
Loading...
