2. HANDLE
1) Put blade screwdriver into a groove on the side of a
Deco handle and lift up a little bit in arrow a direction
and push up with hand in arrow b direction and
disconnect.
2) Put blade screwdriver into a groove on the side of a
DECO handle and lift up in arrow direction c and push
down with hand in arrow direction d and disconnect.
3) Push up a piece handle c in arrow direction with hand
and disconnect.
4) Turn screw in arrow direction with a cross driver and
disconnect.
3. SHROUD, GRILLE FAN
1) Loosen two screws after disconnecting a cap screw of a
grille fan(U) with a balde screwdriver.
2) Disassembly of a grille fan(U) : Pull forward after
opening hook at ➝ part with a blade screwdriver.
3) Disconnect housing A of a grille fan (L) from the main
body.
4) Disassembly of a grille fan (L) : Hold upper part of a
grille fan(L) and pull forward carefully.
5) Loosen two screws.
6) Disassembly of shroud. F(U) : Disconnect housing of B
after removing two rail guides with a blade screwdriver.
7) Disassembly of shroud. F(U) : Hold upper part and pull
forward.
8) Check foam PU sticking conditions around a shroud,
F(U) and F(L) during assembling. If damaged, torn or
badly sticked, assemble with a new one after sealing
well.
HOW TO DISASSEMBLE AND ASSEMBLE
- 89 -
To Next Page
Loading...
