23
Taking Out Ice
[Type1]
1
Rotate the ice separation handle on the
icemaker clockwise.
2
Lift the ice storage bin slightly and remove.
[Type2]
Hold the icetray at its ends and twist gently.
CAUTION
•
If you open and close the freezer door frequently,
it may take longer for water to be frozen.
•
The time for water to be frozen may vary
according to the season.Until 24 hours after initial
installation, the temperature inside the appliance
may not be stabilized so that it may take longer
for water to be frozen.
•
Make sure to be careful as the edges of the
ejected ice may be sharp.
NOTE
•
If ice cannot be detached easily, rotate the ice
separation handle of the icemaker once again.
•
Please note that ice may stick together if you
rotate the ice separation handle of the icemaker
before the water has completely frozen.
•
It takes approximately three hours for water at the
temperature of -20 °C to be frozen completely.
•
When placing the ice storage bin back to its
original position after using, make sure to check
if it is inserted all the way in.
•
The proper storage amount of the ice storage bin
is the amount of ice made three times. If more
than the amount of ice made for three times is
stored, the ice storage bin may not come out and
will become stuck. Do not store more than three
ejected ice trays of ice in the ice storage bin.
Removing the Icemaker (Optional)
1
Hold both edges of the freezer door basket
on top of the icemaker and remove it by
pulling it up.
2
Hold both edges of ice tray compartment
and remove it by pulling it up.
CAUTION
•
Remove in this order. Removing the ice tray rst
may cause damage.
•
When separating the icemaker, hold and remove
it properly to prevent the ice tray from falling off.
To Next Page
Loading...
