LG GS-D600PLC - Page 42

42
MAINTENANCE
2 Pull the pipe out from the water filter cap until
the colored line
a is visble.
3 Push the pipe into the water fitler cap, making
sure the end is fully sealed.
4 Tighten the screw cap until the colored line in
the water filter is no longer visible.
5 Press and hold the Water Filter button for
three seconds. That resets the
Replacement
Filter
icon. The new water filter has been
activated.
6 Dispense water for approximately 5 minutes to
remove trapped air and contaminants from the
system.
Push fit connector type
*1
1 Remove the screw cap.
2 Pull the pipe out from the water fitler.
3 Push the pipe into the water fitler, making sure
the end is fully sealed.
4 Insert the screw cap until the colored line in the
water filter is no longer visible.
5 Press and hold the Water Filter button for
three seconds. That resets the
Replacement
Filter
icon. The new water filter has been
activated.
6 Dispense water for approximately 5 minutes to
remove trapped air and contaminants from the
system.
CAUTION
• Failure to replace filters when required or using
non LG authorised water filters can cause the
filter cartridge to leak and result in property
damage.