Wireless speakers connection
LED indicator of wireless receiver
LED Color Operation
Blue The wireless receiver is
receiving the signal of the
wireless transmitter.
Red The Wireless Receiver is in
standby mode.
O (No
display)
The Wireless Receiver is
turned o.
Initial setting an ID of wireless
receiver
1. Connect the Wireless Receiver and the rear
speaker (right, left) with the speaker cables.
2. Connect the power cord of the Wireless
Receiver to the outlet.
3. Turn on the main unit and Wireless
Receiver: The main unit and wireless
receiver will be automatically connected.
“MATE OK” appears in display window.
Setting an ID of wireless receiver
When the unit is manufactured, the ID is
already set. If an interference occurs or you
use a new wireless receiver, an ID should be set
again.
1.
Turn on the main unit and turn o the
wireless receiver.
2.
Press and hold
x
(STOP) on the front of unit
and MUTE on the remote control. “REMATE”
appears in display window.
3.
Turn on the Wireless Receiver. A new ID is
set.
To Next Page
Loading...
Need help?
General
