51MAKING CONNECTIONS
If you record a TV
programme on a DVD
recorder or VCR, make
sure to connect the TV
signal input cable to the TV
through a DVD recorder or
VCR. For more information
of recording, refer to the
manual provided with the
connected device.
Refer to the external
equipment’s manual for
operating instructions.
If you connect a gaming
device to the TV, use the
cable supplied with the
gaming device.
In PC mode, there may be
noise associated with the
resolution, vertical pattern,
contrast or brightness. If
noise is present, change
the PC output to another
resolution, change the
refresh rate to another rate
or adjust the brightness and
contrast on the PICTURE
menu until the picture is
clear.
In PC mode, some
resolution settings may not
work properly depending on
the graphics card.
Antenna connection
(*Not Provided)
Connect the TV to a wall antenna
socket with an RF cable (75 Ω).
NOTE
Use a signal splitter to use
more than 2 TVs.
If the image quality is poor,
install a signal amplifier
properly to improve the
image quality.
If the image quality is poor
with an antenna connected,
try to realign the antenna in
the correct direction.
An antenna cable and
converter are not supplied.
Supported DTV Audio:
MPEG, Dolby Digital, Dolby
Digital Plus, HE-AAC
To Next Page
Loading...
