installation
9,.,Attach each Frame Curtain the window sash
using screws (Type C),.(S_ Figure 6)
: DO NOT DRILL A HOLE IN THE
8oTr,OM PAN. me unit is ,designed to operate
with approximately 1/2" of water in bottom pan.
c
10. Slide the. unit into the cabinet.(See Figure 7)
" For security purpo_, ireinst_l
screws(Type A), m cabinet's sides.
_rew(Type A}
Power Cord
_rew(Type A} Figu_ 7
11, Cut the Foam-Strip to the proper length
and insert _tween the up_r window sash
and the I!,owerwindow _sh_
(See Figure 8)
Foam Strip
Figu_ 8
12, Attach the Window Locking Bracket with
a Type C screw,., (See Figure 9)
13, Attach the front gdlle to, the c_inet by
inse_ing the tabs o,n the grille into the tabs
on the front of the cabinet. Push the grilie
in until it snaps into place. (See Figure 10)
14. Lift the inlet gdHe and secure it with a Type
A screw through the front grille.
(See Figure 11 )
15. Window installation of room air _nditioner
is now comp_tedo See ELECTRICAL DATA
for attaching _w_" cord to electrical,out/eL
W_r_w Locking Brackot
Figure 9
Figure I0
Figure 11
16 Room Air Conditioner
To Next Page
Loading...