installation
Caution: During the following step, hol.d unit firmly until window _sh
is lowered to top channel _hind side panel frames° Personal injury or'
property damage, may result if un_ falls from window.
,
2_
Open the window. Mark a fine on
center of the window sfoo,l(or desired
air conditioner location).
CarefuBy p_acethe cabinet on lhe
window stool and align the center
mark on 'the bottom front with the
center line markd in the window
stool.
P'ul] the _ttom window sash down
behind the up_r guide until it meets.
:Do not pull the window sash
down _ tightly that the movement of
Frame Cu_ain is,restricted.
3. Lo_liy as_mble the si]li support
using the paris in Figure 3.
4. Select the _itJon that will pl!a_ the
sBi suppo_ near the outer' most point
on sill (See Figure 4),
_i " B,e_reful when you install
the cabinet ,(Frame Guides wBl be
broken easily}.
5_
Attach the sBIsup,_,d to,the cabinet
track hole in relation to _e sei_ted
position using 2 Ty_ A screws in,
each sup_rt(See Figure 4).
6_ The _binet should be instalil_ with a
very s|igh't ti!t(about _tz") downward
toward the, outside (See Figure 5),,,
Adjust the _llt and the nut of sil!
sup_rt for balandngi the cabinet,
7. Attach the @binet to the window stool
by driving the screws (Type B:Length
sixteen miBimete_ and below.) through
the front angle into window stool
8. P'ul] each Frame cut.in fullly to each
window sash track, and repeat step 2
Upper auk_e
_Wi_ow Stool
FromAngle Figure 1
Figure 2
INDOOR
Bo_t
iNDOOR
Nut Figure 3
S_'ew(Type A)
9UTDOOR Figure 4
Scr,ew(TypeB)
StI! SuppoR
Si_i Support
_rew(Type B)
le
Figure 5
Owner_ Manual 15
To Next Page
Loading...