To Next PageTo Next Page
Need help?Do you have a question about the LG LBNK3660BL and is the answer not in the manual?
General| Brand | LG |
|---|---|
| Model | LBNK3660BL |
| Category | Air Conditioner |
| Language | English |
Controls the unit's power status via the remote controller.
Utilizes a thermistor to maintain room temperature based on set points.
Inhibits restarting for approximately 3 minutes for compressor protection.
Allows selection of fan speeds: High, Medium, and Low.
Restarts unit after power failure; automatically sets mode/temp.
Manages defrost cycles and ensures hot start after defrost.
Includes optional drain pump, central, group, and RF controls.
Allows selection of Cooling, Heating, Soft Dry, and Auto modes.
Enables adjustment of fan speed and setting desired temperatures.
Provides functionality for setting timers and weekly operation schedules.
Provides detailed dimensional data for various indoor unit models.
Lists dimensional specifications for different outdoor unit types.
Illustrates indoor and outdoor unit wiring for the LB-S3061/3062BL models.
Details indoor and outdoor unit wiring for the LB-K3661BL model.
Provides indoor and outdoor unit wiring diagrams for LB-K4260BL.
Wiring diagrams for indoor and outdoor units of LB-K4880/4882BL.
Wiring diagrams for the indoor and outdoor units of the LB-H608RSS1.
Wiring diagrams for indoor and outdoor units of the LB-M7280BL series.
Wiring diagrams for indoor/outdoor units of LB-M9080BL/LB-M1081BL.
Details safety time delays and the soft-dry fan speed setting.
Describes unit operation based on intake air and set temperature.
Details heating operation based on intake air and set temperature.
Indoor fan behavior until evaporator piping reaches 31°C.
Explains defrost conditions and error code display.
Guidelines for selecting the optimal location for the indoor unit.
Guidelines for selecting the optimal location for the outdoor unit.
Specifies maximum piping length and elevation differences allowed.
Details for ceiling mounting and suspension/console bolt placement.
Advice on suitable and unsuitable installation locations.
Guidance on selecting placement and height for the remote controller.
Instructions for properly routing the remote controller cable.
Steps for disassembling and mounting the wired remote control.
Steps for correctly installing batteries in the remote control.
Instructions for connecting wires to the indoor unit terminals.
Steps for securing power and connecting cables with clamps.
Specifies circuit breaker ratings based on unit capacity.
Details wiring connections and earthing for indoor/outdoor units.
Steps for cutting, deburring, nut installation, and flaring pipes.
Steps for connecting refrigerant pipes between indoor and outdoor units.
Instructions for removing air and moisture from refrigerant lines.
Specifies the correct torque values for tightening flare nuts.
Importance of unit declination for proper water drainage.
Guidelines for maintaining correct gradient and using U-traps.
General requirements for thermal insulation of components.
Instructions for insulating and taping gas and liquid refrigerant pipes.
Final steps for shaping and securing refrigerant pipes.
Essential safety and operational checks before and during test running.
Items to verify after installation is complete, including air circulation and leaks.
Steps for connecting the unit to the main power supply with circuit breaker.
How to measure and verify unit performance after connection.
Details the three selectable modes for the dual thermistor system.
How to connect and operate multiple units as a group.
Detailed steps for connecting indoor and outdoor unit refrigerant piping.
Steps for safely disconnecting the unit for relocation.
Detailed steps for charging the system with refrigerant.
Analyzes issues based on temperature differences and operating current.
Verifies temperature and pressure readings in the refrigeration cycle.
Step-by-step guide for diagnosing why the unit does not operate.
Diagnoses issues when the indoor fan fails to operate.
Guides for resolving problems related to ineffective heating.
Steps to diagnose and fix issues with the wired remote controller.
Exploded diagram and parts list for the LBNS3061BL indoor unit.
Exploded diagram and parts list for LBNS3062BL/LBNK3661BL indoor units.
Exploded diagram and parts list for LBNK4260BL series indoor units.
Exploded diagram and parts list for the LBNH608RSS1 indoor unit.
Exploded diagram and parts list for the LBUM7280BL indoor unit.
