LG LFXC22526 series - Page 179

Washer Lock Error LE
The LE error indicates a problem with the Direct Drive
motor control. Note: the appliance has a load detection
and correction system. If any overload is detected
Washer foreign object LE1
check for coins pins, clips, etc caught between wash plate
the inner basket
Washer Wi-Fi communication error nE
The nE error indicates a problem with the connection
between the Display PCB and the Wi-Fi module.
Not connected: a faulty harness: a faulty Display PCB: a
faulty Wi-Fi module
Washer Wi-Fi module problem nF
The nF error indicates a problem with the Wi-Fi module.
Self Check function Error
Unplug the appliance. Wait for 60 seconds and restart the
appliance if error reappears maybe a faulty Wi-Fi module
Washer Outlet Error: Draining Problem OE
The OE error indicates a problem with draining the water.
Note: the appliance has a drain detection and correction
system
Washer Pressure Error PE
The PE error indicates a problem with the Pressure switch
(water level sensor). The appliance will stop as it cannot
continue in the program.
a problem with the water level sensing: a problem with
foam in the air chamber hose: a faulty pressure switch: a
faulty Main PCB
Washer Power Failure PF
The PF error is a notification that an external short power
outage has occurred. Restarting the appliance restores it
to the stage where it has stopped.
No further actions required
Washer/combo Restricted dry fan PF
also used to indicate a restricted dry fan in a washer dryer combo
for Washer-Dryer Combo
Washer Sensor Error SE
The SE error indicates a problem with the BLDC motor
rotation and force detection. The tacho sensor cannot
provide a proper signal to the controller.
a faulty tacho sensor: a faulty Main PCB
Washer Sud Error Sud
Washer Tub Clean tCL
The tCL error is a notification that the appliance should run
a maintenance program to clean the tub. Note: This
program runs with a higher water level
Washer Thermistor Error tE
The tE error indicates a problem related to the heating
system. The appliance has stopped to prevent further
damages.
a failing heater protection: a faulty Main PCB
Washer Unbalance Error UE
The UE error indicates a problem with balancing of the
load. Note: the appliance has an balance detection and
correction system with an automatic untangle process. If
the untangling of the load did not result in an even
distributed load
Washer Unbalance Error uE
information code for user redistribute load