Service Bulletin
Page 4
2) Disassemble the Noise Filter, Power Cord, Inlet Valve,
Pressure Switch, and Dispenser Housing
- Noise Filter and Power Cord
① Remove the two (2) screws attaching the noise filter.
② Disconnect both connectors in the noise filter.
Remove the power cord from the noise filter.
- Inlet Valve
① Disconnect the leads from the inlet valve and remove three
(3) screws.
② Remove the hoses and output pipes from the input valve.
③ Remove the inlet valve.
- Pressure Switch
① Disconnect the leads from the pressure switch and detach
the pressure switch from the machine.
② Disconnect the pressure tube from the pressure switch.
- Dispenser Housing
① Remove the hoses and output pipes from the input valve.
② Disassemble the connector pipe and the dispenser housing.
Product : Top loader washer
Bulletin # : DFZ201900071-02
Release Date : 2019.05.27
To Next Page
Loading...
