12
ENGLISH
Using the Sound Eect function
(Settings) Sound Sound Mode Settings
The user can select various sound eects.
• Treble : Controls the dominant sounds in the output.
• Bass : Controls the softer sounds in the output.
• Reset : Reset the sound eect settings.
• This is only available if Sound Mode is set to Standard.
To set Auto Volume
(Settings) Sound Auto Volume
Sets Auto Volume to On. Varying volume output from programme to
programme is automatically adjusted for convenient TV watching when
clicking through dierent programme.
To use Sound Test
(Settings) Sound Sound Test
Start the Sound Test to check that the sound signal output is normal,
and then select whether there is an error.
If there are no problems in the test, check the connected external device
or broadcast signal.
Using Manual Tuning
(Settings) Programmes Manual Tuning
Adjusts programmes manually and saves the results.
For digital broadcasting, signal strength and signal quality can be
checked.
For analogue broadcasting, you can set up station names and use
ne tuning (except for Satellite mode). Normally ne tuning is only
necessary if reception is poor.
Editing programmes
(Settings) Programmes Programme Manager
Edits the saved programmes.
Set as favourite programme, block/unblock programme, skip
programme etc. of the selected programme.
To select Programme mode
(Settings) Programmes Programme Mode
[This feature is available on certain models only.]
This function allows you to watch a tuned programme in Antenna or
Cable.
• You can only watch programmes in the selected mode.
Data Service Function
(Settings) Programmes Data Service
[This feature is available in certain countries only.]
This function allows users to choose between MHEG (Digital Teletext)
and Teletext if both exist at the same time.
If only one of them exists, either MHEG or Teletext is enabled regardless
of which option you selected.
To use Signal Test
(Settings) Programmes Signal Test
[This function is available on certain models or in certain countries only]
Shows the MUX and Service information etc..
Signal test is only available in Antenna or Cable mode.