24
ADJUSTING THE TEMPERATURES AND DISPLAY
Adjust Freezer Temperature
To adjust the temperature in the freezer
compartment, press the FREEZER button to cycle
through the the range of available settings.
Adjust Refrigerator Temperature
To adjust the temperature in the refrigerator
compartment, press the REFRIGERATOR button to
cycle through the range of available settings.
NOTE: The actual inner temperature varies
depending on the food status, since the indicated
temperature setting is the target temperature and not
the actual temperature within the refrigerator.
Initially set the REFRIGERATOR CONTROL at 37
degrees F and the FREEZER CONTROL at 0
degrees F. Leave them at these setting for 24 hours
(one day) to stabilize. Then adjust the compartment
temperature as illustrated above.
ww
CAUTION
Display mode setting and its cancellation
1. With the refrigerator door open, keep pressing the
REFRIGERATOR Button and ICE PLUS Button
more than 5 seconds, then it goes to the display
mode with special beep sound.
2. Perform the same way again to cancel the display
mode.
3. All cooling unit will be turned off at display mode
(Exceptions: Lamp, Displa
y).
Temperature Display
To change the temperature display from Fahrenheit
to Celsius:
• Simultaneously press and hold the FREEZER and
REFRIGERATOR buttons for more than 5 seconds.
• Do the same to convert back to Fahrenheit.
Power Saving Mode
• The display will remain off until the next time the
door is opened.
The display will also turn on when any button is
pressed, and it will remain on for 20 seconds after
the last door opening or button selection.
• To deactivate the Power-Saving Mode, press the
FREEZER and ICE PLUS buttons simultaneously
and hold them for 5 seconds until the tone sounds.
NOTE: Power Saving Mode function is set on the
product.
To Next Page
Loading...
Need help?
General
