10
ENG
ENGLISH
ASSEMBLING AND PREPARING
Attaching the TV to a table
(Only 39/42/47LN549C, 39/42/47LN549E, 42/47LP36**,
42/47/55LP62**)
Image shown may differ from your TV.
The TV must be attached to desk so it cannot be
pulled in a forward/backward direction, potentially
causing injury or damaging the product.
(not provided as parts of the product)
4-Screws
Stand
Table
Screws: M5 x L (*L: Table depth + 8-10 mm)
ex) Table depth: 15mm, Screw: M5 x 25
Securing the TV to a table
Fix the TV to a table to prevent from tilting forward,
damage, and potential injury.
To secure the TV to a table, insert and tighten the
supplied screw on the rear of the stand.
WARNING
y
To prevent TV from falling over, the TV should be
securely attached to the floor/wall per installation
instructions. Tipping, shaking, or rocking the TV
may cause injury.
Adjusting the angle of the TV to suit view
(Only 32LN54**, 32LP36**, 32LP62**)
Swivel 15 degrees to the left or right and adjust the angle
of the TV to suit your view.
15˚ 15˚
(Only 39/42/47/55LN549C, 39/42/47/55LN549E,
42/47LP36**, 42/47/55LP62**)
Swivel 90 degrees to the left or right and adjust the angle
of the TV to suit your view.
90˚ 90˚
CAUTION
y
When adjusting the angle of the product, watch
out for your fingers.
»
Personal injury may occur if hands or fingers are
pinched. If the product is tilted too much, it may fall,
causing damage or injury.
To Next Page
Loading...
