WATER DRAINAGE
This product has a self-evaporative system. The condensing water will be recycled to cool the
condenser. This can not only improve cooling efficiency, but also save energy for you.
· Under the Cool or Fan mode, there`s no need of water drainage
·
During dehumidifying mode, remove the drain plug and the exhaust hose from the back of the unit.
·
If the internal water container is full, the LCD-display will flash “P2” and the unit will stop automatically.
Note:
If the water full alarm is often on, there may be some malfunction about the unit.
Contact the professional service for help.
Unplug the air conditioner, disconnect the exhaust
hose from the back, and move the air conditioner to
a suitable drain location or outdoors. You may also
place a pan under the drain that will hold up to 1
quart of water.
When the internal water collection tank is full, the air conditioner will turn off until the tank is
emptied.
Remove the drain cap from the drain outlet.
Once the water collection tank is drained,reinstall the
drain cap, making sure it is on securely.
Place the air conditioner in the desired location,
reconnect the exhaust hose, and plug in the air
conditioner.
YW
CARE AND CLEARING
Using the Upper Drain Port ( Dry Mode Only)
Using the Bottom Drain Port
P2 apperars in the display
The water collection tank is full, drain the tank and reset your setting.
NOTICE
,QVWDOODGUDLQKRVHijPPLQQHUGLPHQVLRQDQGSODFHWKHRSHQ end of the hose a suitable drain location
or outdoors.
·
· When need dehumidification in high humidity
To Next Page
Loading...
Need help?
General
