3) Form the pipings
1. Wrap the connecting portion of indoor unit with
the lnsulation material and secure it with two
plastic Bands (for the right pipings).
• If you want to connect an additional drain hose, the
end of the drain-outlet should keep distance from
the ground.(Do not dip it into water, and fix it on the
wall to avoid swinging in the wind.)
2. Tape the pipings, drain hose and Connecting
Cable from down to up.
3. Form the pipings gathered by taping along the
exterior wall and fix it onto the wall by saddle
or equivalent.
2. Tape the pipings and Connecting Cable from
down to up.
3. Form the pipings gathered by taping along the
exterior wall and the Trap is required to prevent
the room from entering the water.
4. Fix the pipings onto the wall by saddle or
equivalent.
In case of the Oudoor unit to be installed
below the Indoor unit
In case of the Outdoor unit to be installed
upper position of the Indoor unit
ƒ¡37ƒ¡
To Next Page
Loading...
