23) Entering to the Test Mode
How to make DISPLAY CHECK MODE
In order to check hidden error codes, or Display functionality.
To enter to this mode, press simultaneously “ULTRA ICE” button and “FRZ TEMP” button for more than 5 seconds.
If no are errors detected, all LED’s will be turned ON, otherwise, error code will be displayed.
24) Removing TPA’s (Terminal Position Assurance)
How to remove TPA’s
1) Press and lift the clips located on each side of connector.
2) Lift TPA by the center of connector.
1) Press and lift a lateral clip.
2) Lift the hooks in the front of connector.
3) Press and lift the remaining clip.
4) Lift TPA by the center of connector.
AC TPA DC TPA
NOTE: After make measurements, be sure that TPA was assembled in connector.
- 119 -
Press simultaneously for
more than 5 seconds
To Next Page
Loading...
