NOTE: Allow hot foods to cool at room temperature for
30 minutes, then package and freeze. Cooling
hot foods before freezing saves energy.
WATER AND ICE DISPENSER
Your refrigeratorhas a mechanism that dispatch cool
water and ice cubes without open the door.
• Tray can be easilyremoved by pressing and pullingit.
• First push the tray in the area with the word 'PUSH',
then place your finger in the center hole and upwards,
finally takes out the tray.
place easily, twist the drive device slightly.
• Hold the ice storage bin _l}and pull it out while slightly
lifting it _2_shown in the figure.
• To assemble the ice storage bin, push it_3_while slightly
lifting it (_).
• Make sure it is fully engaged into the auger drive (_).
WARNING
Do not putyour hands into the water
& ice dispenser opening. Doing so
may cause an injury to your hand.
ICE MAKER COVER
If you need access to the ice maker, follow these steps:
• Lift the ice shelf (1_and pull itS2} out as shown in the
figure below.
CAUTION
When opening the container with
the small opening, use it near the
opening of the water or ice dispenser
as close as possible.
DOOR RACK AND SUPPORT
Your refrigerator and freezer features racks which can
easily be arranged for packaged products.
• Lift the door rack holding both sides (17and pull it out
in _2_direction.
ICE STORAGE BIN
The ice bin stores the ice cubes made by the ice maker. If
you need to remove the ice storage bin, do so as follows:
NOTE: Use both hands to remove the ice bin to avoid
dropping it. If the ice bin does not slide into
16
To Next Page
Loading...
