WATER FILTER • Push the water filter up into the filter receptacle and
Filter Reset: When the filter icon turns on, you
have to change the water filter. Press the Filter
button for 3 seconds to turn the icon off.
Before removing or installing water filter:
• IMPORTANT: Turn off household water supply.
• Take out the top shelf and move it to the lowest level.
rotate it clockwise to lock it into place. Once installed
the lock symbol _ should be facing you andcorrectly,
you should not be able to rotate the filter clockwise
anymore.
Removing the Water Filter
• Remove old filter by turning it counterclockwise a
quarter turn and pulling it down. The substitute cap
must be retained for the future. If the filter is removed
and not replaced, it is necessary to reinstall the
substitute cap to prevent water leaks from the filter
housing.
\ /
NOTE: After installation, if you notice that the lock symbol
is not facing you or you can continue to rotate
the filter clockwise; remove the filter and repeat
installation to prevent water leaks.
After installing the Water Filter
• Replace the shelf to the initial position.
• After installing filter, turn on household water supply.
• Dispense 2,5 gallons (9,46 liters) of water to purge the
system, depressing and releasing the dispenser pad in
cycles of 30 seconds ON and 60 seconds OFR Open
the refrigerator door and check the shelf area for water
leaks.
To purchase or replace water filters, call your Service
Center. Refer to the Warranty Card to obtain the
telephone number of the Service Center near you and
ask for part no. 5231JA2002A or ADO72910901.
Installing the Water Filter
• Remove the red cap from the filter.
• Hold the filter with the unlock symbol [_ facing
towards you as shown in the figure below. Insert the
filter into the filter receptacle on the right side of the
refrigerator compartment.
19
To Next Page
Loading...
