Remove the
Freezer
Compartment
Door
Remove the
Refrigerator
Door
Installation
1) Remove the hinge cover by loosening the
screws. Disconnect all connections except
the ground line.
2) Remove the keeper by rotating it counter
clockwise and then lifting the upper
hinge up
.
3) Remove the freezer compartment door by
lifting it upward. This time, the door should
be lifted enough for the water feed tube to
be completely pulled out.
1) Loosen the hinge cover screws and remove
the cover. Remove connection wire.
2) Remove keeper by rotating it clockwise
and then remove the upper hinge by lifting
it up .
3) Remove the refrigerator compartment door
by lifting it up.
•
If a tube end is deformed or abraded, trim the part away.
Disconnecting the tube under the door causes about 1.5 litters water to out. Please
put a large container at end of tube to prevent water from draining on to the .
NOTE
•
When removing the upper hinge, be careful that the door does not fall forward.
NOTE
•
After removing the door, take it into the kitchen where you are installing the
refrigerator. Lay it down on a blanket and be careful to avoid damaging the water
feed tube.
NOTE
Lower hinge
Lower Hinge
Keeper
Connection
Wires
Connection
Wires
Hinge
Cover
Upper Hinge
Upper Hinge
Keeper
Upper Hinge
6
8
Failure to do so could result in death or serious injury.
If your entrance door is too narrow for the refrigerator
to pass through, remove the
refrigerator door and pass
the refrigerator laterally.
Push the refrigerator sideways
through the entrace door as shown in the rigth picture.
Electric Shock Hazard
Disconnect electrical supply to refrigerator before installing.
Pull up the water feed tube while pressing
area shown in the gure to the right.
Water Feed Tube
Remove Water
Feed Tube
WARNING
Move the
Refrigerator
To Next Page
Loading...
