Pass the Passthe refrigeratorlaterallythroughthe access
refrigerator dooras shown inthe right figure.
Before
installation
Warning
Disposal of the
old appliance
Mount the freezer and refrigerator
compartment doors
Mount them inthe reverse sequence of removal after they passthrough the access
door.
Water supply installation
• Automatic icemaker operation needs water pressure of 21N121 psi (1.5N8.5
kgf/cm2)(That is, an instant paper cup (6 oz. or 180 cc)will be fully filled within
3 seconds.)
• If water pressure does not reach the rating 21 psi (1.5 kgf/cm 2)or below, it is
necessary to purchase a separate pressure pump for normal automatic icing and
cool water feed.
• Keepthe total length of the feed water pipe tube within 26' (8 m). Be careful for the
tube to avoid being kinked. If the tube is 26' (8 m) or longer it may cause trouble in
water feed owing to the drain water pressure.
• Install the water supply line where it will not be affected by heat.
• Connect to potable water supply only.
This appliancecontains fluids (refrigerant and lubricant) and is made of parts and
materials which are reusable and/or recyclable.
All the important materials should be sent to the collection center of waste material
and can be reused after rework (recycling).For recycling, please contact the local
agency.
To Next Page
Loading...
