FORCED OPERATION
Operation procedures when the remote control
can't be used.
Press the Forced Operation button.
If you want to stop operation, press again.
When started, the operation conditions are
automatically set as follows:
During Forced Operation, the initial mode
continues.
FORCED OPERATION
AUTO RESTART
In case the power comes on again after a power failure, Auto Restarting Operation is the function to
operate procedures automatically to the previous operating conditions.
In case the air conditioner does not receive any signal from the remote control, it will turn off
automatically after 7 hours.
Heat pump Model
Cooling Model
Room Temp. ≥ 24°C 21°C ≤ Room Temp. < 24°C Room Temp. < 21°C
Operating mode Cooling Cooling Soft Dry Heating
Indoor FAN Speed
High High Soft Dry Rule High
Setting Temperature
22°C22°C Air Intake Temperature 24°C
When the front grille is opened:
Once the front grille is opened for cleaning of the air filters or other reasons, the unit automatically
stops operation for safety: In some 60 Hz models (for cooling only), all memorized functions such as
operation mode, room temperature setting, operation start & stop by timer setting, etc. shall be
erased.
To restart the unit, close the front grille and press the Start/Stop button on the remote controller. If
necessary, please reset the reservation functions like operation start & stop and room temperature
setting.
To Next Page
Loading...
