11
Copyright © 2022-2023 LG Electronics Ins.
All right reserved.Only training and service purposes.
Disassembly
6. Shroud
1. Remove the fan. (Refer to section 5)
2. Remove the 3 screw that fastens the shroud.
3. Remove the shroud. (See Figure 8)
4. Re-install the component by referring to the removal
procedure, above.
7. Overload Protector
1. Remove the cabinet. (Refer to section 2)
2. Remove the nut that fastens the terminal cover.
3. Remove the terminal cover. (See Figure 9)
4. Remove all the leads from the overload protector
5. Remove the overload protector.
6. Re-install the component by referring to the removal
procedure, above.
Figure 8
Figure 9
Figure 10
Electrical Parts
8. Compressor
1. Remove the cabinet. (Refer to section 2)
2. Discharge the refrigerant system using a Freon™
Recovery System.
If there is no valve to attach the recovery system,
install one (such as a WATCO A-1) before
venting the Freon™Recovery System.
Leave the valve in place after servicing the system.
3. Remove the overload protector. (Refer to section 7)
4. After purging the unit completely, unbraze the suction
and discharge tubes at the compressor connections.
5. Remove the 3 nuts and the 3 washers
that fasten the compressor.
6. Remove the compressor. (See Figure 10)
7. Re-install the components by referring to the removal
procedure, above.
To Next Page
Loading...
