REMOTE CONTROLLER
POWER
Operation starts when this button is pressed and stops when
you press the button again.
FAN SPEED SELECTOR
For increased power while cooling,select a higher fan speed.
3 steps:High
Low.
Med
ON/OFF TIMER
OPERATION MODE SELECTOR
Please refer to page 18 in details
a. Press MODE until you see the indicator light glow for the
desired setting.
b. Choose Fan, Cool, Energy Saver or Dehum.
Fan—Only the fan runs. Press SPEED to select High, Med
or Low fan speed. The display shows the current room
temperature.
Cool—Cools the room. Press SPEED to select High, Med
or Low fan speed. Press the TEMP/TIME up or down
arrow button to adjust the temperature.
Energy Saver—Fan runs only when cooling is needed.
fan speed.Because the fan does not circulate the room
air continuously, less energy is used, but the room air
is not circulated as often.
Dehum—Dries the room. The air conditioner automatically
selects the temperature.
The fan will have a running delay for 1 or 2 min after the
cooling stops. Press SPEED to select High, Med or Low
To Next Page
Loading...
