LG LZ-H080GBA4 - Method to Connect Power Cord

Installation manual 15
Installation
ENGLISH
Cover of control box
Screw
Cord clamp
LZ-H025GBA4/LZ-H035GBA4/LZ-H050GBA4
LZ-H080GBA4/LZ-H100GBA4
LZ-H150GBA4/LZ-H200GBA4
1(L)
GND
2(N)
3(L) 4(N)
M.D.
GN/YL BR BL
Not
available
GND Power M.D. M.D.
1(L)
GND
2(N)
3(L) 4(N)
M.D.
GN/YLBR BL
Not
available
GNDPower
Method to connect power cord
Release two screws and then open the
cover of the control box.
•
With reference to the below wiring diagram, accu-
rately connect the main power cords into the termi-
nal block.
After inserting the power cord into the bushing, fully insert it into the termi-
nal block for connection.
• Fix the power cords with the clamp.
• Make sure that the power cords may not be removed by pulling them.
Wiring specifications
Wiring specifications Sheathed wire (should be complied with 60245 IEC 53 standard)
Size 0.75 - 1.25 mm
2
Length MAX. 100 m
External contact specifications Normally closed contact (Current tolerance 10 mA - 0.5 A)
Precautions when laying power wiring
Use round pressure terminals for connections to the
power terminal block.
Round pressure terminal
Power wire
The power cord connected to the unit should be selected according to the following specifications .
CAUTION
Indoor unit ground wires are required for preventing electrical shock accident during current leakage,
Communication disorder by noise effect and motor current leakage (without connection to pipe).
WARNING