LG M3200C-BAF - RS-232 C Advanced Control Commands; Commands for Source, Auto Configure, and Key Codes

A12
ENGLISH
18. PIP/PBP/POP SOURCE(Command : y)
To select the sub-screen source.
Transmission
[k][y][ ][Set ID][ ][Data][Cr]
Data 2 : AV 6 : RGB1
3 : S-Video 7 : RGB2
4 : Component 1 8 : DVI
5 : Component 2
Acknowledgement
[y][ ][Set ID][ ][OK][Data][x]
Data 2 : AV 6 : RGB1
3 : S-Video 7 : RGB2
4 : Component 1 8 : DVI
5 : Component 2
19. Auto Configure(Command: j u)
To adjust picture position and minimize image shaking
automatically. it works only in RGB(PC) mode.
Transmission
[j][u][ ][Set ID][ ][Data][Cr]
Data 1 : To set
Acknowledgement
[u][ ][Set ID][ ][OK][Data][x]
20. Key(Command : m c)
To send IR remote key code.
Transmission
[m][c][ ][Set ID][ ][Data][Cr]
Data Key code : Refer to page A18.
Acknowledgement
[c][ ][Set ID][ ][OK][Data][x]
Transmission / Receiving Protocol
▲
▲
▲