To Next Page
M
Melissa PittmanSep 12, 2025
What to do if clone is not working on LG TV?
- RRyan JenningsSep 12, 2025
If the LG TV clone is not working, try a different clone programmer or reset the clone programmer.
What to do if clone is not working on LG TV?
If the LG TV clone is not working, try a different clone programmer or reset the clone programmer.
How to set time on LG TV clone?
If no time is set on your LG TV clone, set the time on a TV, and copy the time to the clone programmer.
Why does clone scan channels more than once on LG TV?
If the clone scans channels more than once on your LG TV, ensure the TV is set up correctly, and try cloning again. The clone should only scan channels once.
What to do if cloning did not work on LG TV?
If cloning did not work on your LG TV: * Wait until the procedure complete message is displayed, as the procedure may have been interrupted. * Cloning is only possible with identical model TVs if there are different TV models. * Refer to the applicable cloning procedure(s), and make sure all tasks were performed, as steps may have been omitted or not performed.
Why is my LG TV remote not working?
If the remote isn't working with your LG TV, there are several possible reasons: * The remote may not be in TV Mode. Use the MODE key to select 'TV'. * You may not be aiming the remote at the IR remote sensor on the TV, so point the remote directly at the sensor. * The remote might be too far from the IR sensor, so move closer or darken the room. * If applicable, the MPI cable might not be connected, so connect the MPI cable to the MPI device. * There might be an obstruction in the IR path to the TV's receiver, so remove any obstructions. * The batteries might be weak, so replace them. * The battery polarity might be incorrect, so check that '+' and '-' match in the battery compartment. * There might be too much light in the room, so dim the lights. * You might be using ...
General
