Getting Started
5
1
Getting Started
FCC Compliance Statement
This device complies with part 15 of the FCC rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment o and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
y
Reorient or relocate the receiving antenna.
y
Increase the separation between the equipment and receiver.
y
Connect the equipment into an outlet on a circuit dierent from that
to which the receiver is connected.
y
Consult the dealer or an experienced radio/TV technician for help.
CAUTION : Any changes or modications not expressly approved by
the party responsible for compliance could void the user’s authority to
operate this equipment.
FCC WARNING: This equipment may generate or use radio frequency
energy. changes or modications to this equipment may cause harmful
interference unless the modications are expressly approved in the
instruction manual. The user could lose the authority to operate this
equipment if an unauthorized change or modication is made.
NP8350B-M0.BUSALLK_SIM_MFL69154860.indd 5 2015-07-24 8:59:37
To Next Page
Loading...
