LG OLED88Z2 Series - Page 34

- 34 -
Copyright © LG Electronics Inc. All rights reserved.
Only for training and service purposes.
(6-1) Tighten the Sound Reector. (Attached with magnet)
* Check the DC Cable clearance before the Sound Reector tightening. The Sound Reector does not tighten properly if the DC
Cable is protruding.
(6-2) Screw the Sound Reector Fixation Screw(B) 2EA
* Be careful not to scratch inside the stand when Sound reector is assembled to Stand.
Sound Reflector
6-2
B
6-1
Sound Reflector
Refle c to r attached by ma gn e t.
※Check the DC Cable before assemble Reflector to Stand.
Cable protrudes to the outside (NG)
Cable does not protrude
to th e ou ts id e (OK)