To Next PageTo Next Page
Need help?Do you have a question about the LG PA11K and is the answer not in the manual?
Provides essential safety advice for servicing the TV chassis.
Procedure for checking AC leakage current with the TV powered on.
Procedure for checking AC leakage current with the TV unplugged.
Defines the scope and general technical specifications of the TV.
Outlines testing procedures and details for the display module.
Lists supported markets and broadcasting system standards.
Specifies the context and parameters for adjustment procedures.
Guides on checking the Main PCB and performing boot file downloads.
Step-by-step instructions for updating firmware via USB.
Details the ADC process and calibration steps.
Procedures for RS232C controlled adjustments and white balance.
Outlines assembly steps and power PCB voltage adjustments.
Guides on manual white balance adjustment and DPM confirmation.
Instructions for writing and automatically downloading EDID data.
Explains manual download and provides EDID data specifics.
Procedures for checking EYE-Q operation and 3D functionality.
Steps for downloading model name and serial number.
Details signal table parameters and command sets.
Guides for downloading and checking CI+ key values.
Verifies RS232C commands and CI+ key status.
Instructions for performing software downloads using a USB drive.
Overview of main IC, memory, and 3D chip components.
Details the PDP module and system interfaces.
Visual breakdown of parts with critical safety warnings.
Schematics for Full SCART, CI Slot, and Half SCART/Component.
Schematics for various input/output ports.
Schematics for tuner, audio amp, LVDS, and IR receiver.
Schematics for video, DDR memory, and power sections.
Schematics for various memory components.
Schematics for specific voltage rails in the power supply.
Schematics for LG8300 reset and RF emitter interface.
Procedures for checking and adjusting Y-Sus board voltages.
Procedures for checking and adjusting Z-Sus board voltages.
Method for checking fuses using a digital multimeter.
Procedures for diagnosing the Y-Sus board components and voltages.
Procedures for diagnosing the Z-Sus board components and voltages.
Procedures for checking control board voltages, LEDs, and ICs.
Analysis of symptoms related to mal discharge issues.
Methods for checking the module ROM version via label and remote.
Procedures for checking the Y Drive board, focusing on the scan IC.
Diagnosing half picture issues and checking X board connections.
Analysis of defect types originating from the PDP module.
Description of connector types and associated defect symptoms.
General
