LG Pro Centric 55ET960H - Page 80

80
206-4350
(Continued from previous page)
• When you have entered all the beacon identication data, select the the
Wheel (OK) button button at the bottom of the menu, and then press the
Wheel (OK) button on the Installer Remote.
• At the prompt for broadcast conrmation, select either Yes to broadcast
the Beacon or No if you do not want to broadcast the Beacon.
5. If desired, you can specify a name for this TV so that it is easy to identify
and differentiate from other TVs for which sharing has been/will be enabled.
Note: By default, the TV name is the TV’s serial number + model name.
However, if a room number is specied in the EZ-Manager Wizard or in the
General Menu / Room Info screen, the TV name is changed to the room
number.
To edit the TV name, use the Up/Down arrow keys to select the TV Name
eld, and then press the Wheel (OK) button. You can then use the number
keys on the Installer Remote to directenter a numeric TV name, or you can
use the arrow keys to select the appropriate alphanumeric character(s) from
the pop-up virtual keyboard at the bottom of the screen. When you are
done, select Enter from the virtual keyboard, and then press the Wheel (OK)
button on the Installer Remote.
6. Once all elds are completed as required, use the arrow keys on the Installer
Remote to return to the IP Environment Menu, as necessary, or press BACK/
EXIT to exit the IP Environment Menu.
Note: While Smart Share, Screen Share, Media Renderer, DIAL, and Beacon
settings are clonable, SoftAP settings, as well as the TV name cannot be cloned.
IP Environment Setup (Cont.)