54
Chapter 5. Removing and replacing a part (FRU)
Note
-As for the screw, every Torque 3 0.2Kgfcm(0.196Nm)
-For further information on Removing and Replacing a Part(FRU), refer to Explore view.
Danger
Before removing any FRU, power off the computer, unplug all power cords from electrical
outlets, remove the battery pack, and then disconnect any interconnecting cables.
Caution
Before the computer is powered on after FRU replacement, make sure that all screws, springs,
and other small parts are in place and are not loose inside the computer. Verify metal flakes can
cause electrical short circuits.
Ch5. Removing and replacing a part
To Next Page
Loading...
