14
Adjust the SETUP settings - more you can do
Adjust the general settings
Auto Programming – This option automatically scans and sets the available
channels.
[Start]: Start the channel scanning.
Program Edit– This option allows you to add channels and edit preset
channels.
[Edit]: Displays the screen which show preset channel list and channel
editing options. (page 12)
Clock Set– The clock must be set in order to use [Timer record].
TV Aspect – Selects the aspects ratio of the connected TV.
[4:3 Letter Box]: Select this when connecting to a standard 4:3 screen TV
and prefer the wide picture with bands on the upper and lower portions of the
screen.
[4:3 Pan Scan]: Select this when connecting to a standard 4:3 screen TV and
prefer the wide picture on the entire screen cuts off the portions that do not
fit.
[16:9 Wide]: Select this when connecting to a wide-screen TV.
VCR Play System – Your video recorder uses triple colour standards, PAL,
MESECAM and Auto. During play your video recorder should select the colour
system automatically, however if you experience problems you may need to do
it manually.
Power Save mode – Selects whether this unit is in power save mode when the
power is turned off. This option is not available when a timer recording is set.
[ON]: The front panel display is off and only signals arriving at the antenna
input are passed through when the unit is turned off.
[OFF]: Turns off the [Power Save Mode].
Factory Set – You can reset the unit to all its factory settings. Some options
cannot be reset (Rating, Password, and Area Code). The auto setup menu
appears on the screen after the factory settings.
To Next Page
Loading...
Need help?
Power
Operating Environment
Weight and Dimensions
