3. Convert LCD Display to Data View Mode.
4. After Start, when the first Pumping is completed, put 1/3 water in Drawer, and pour around
Dispenser water discharge hole slowly until "Sump W" value becomes "001" among
Data View categories.
(When it becomes "001", water supply shall be stopped immediately.)
5. Check electric parts , mechanical parts, hose connection in the left bottom and water
leakage at the bottom of Base.
( Refer to page41 )
( Refer to picture E , page35 )
( Refer to picture F , page35 )
-. Pump Cover assembly status
(Gap, Screw missing, etc.)
NO The course Show details
1
2
3
4
5
6
7
8
9
10
11
12
Refresh
Skin Care
Jeans
Bulky Item
Easy Care
Mixed Fabric
Cotten
Sports Wear
Quick Dry
Delicate
Wool
Rack Dry
Humidity values
Low Temp
Comp Temp
T_heater (High Thermistor)
Eva in Temp
Sump Water Level
Drain Pump RPM
LEV Pulse
Main PGM Tool
Main Version
※Check the status of the actions Sensor
- Drum Light + Buzzer 3 when entering
Pressing enter, Once again press the same key
fot three seconds to escape.
- Turn the Jog Dial in data view state data can be
checked as shown below.
- Not to enter the Child lock status.
- Apply the model : Only Touch LED model.
To Next Page
Loading...
Need help?
General
