Caring for Your Dryer
17
C
aring for Your Dryer
1. Take
connecting
kit out.
Ventilation Grille and Cool Air
Inlet Grille
Vacuum the front ventilation grill 3~4 time a year to
make sure there must be no build-up of lints or dirts
which cause improper intake air flow.
Moisture Sensor?
This device functions to sense the moisture
remaining contents of the laundry during
operation which means it must be cleaned all
the time. The main reason of cleaning this part
is to remove the build-up of lime scale on the
surface of sensor. Wipe the sensors inside drum
(Shown in the picture).
2. Separate
water
container
hose from
the kit.
3. Connect
drain hose
to the kit.
Condensed Water Drain-out
Normally, condensed water is pumped up to water
container where water is collected until emptied.
Not only using water container, but water can be
drained out directly to drain hose especially when
dryer is stacked on top of washing machine.
With connecting kit for drain hose, you can simply
change water path and water reroute to the drainage
facility. Please follow the below steps.
Note
The warm air is exhausted through the
ventilation grill.
To Next Page
Loading...
Need help?
General
