Top / Front Panel
F
b
d
c
a
Side / Rear Panel
POWER IN
AUX
POWER IN
a b
c d
e
a
PORT. (Portable) IN jack
b
USB Port
You can play sound les by connecting the USB device.
c FM ANTENNA
d AUX IN (L/R)
Connect an auxiliary device.
e POWER IN
a
Display window
b
1
(Standby)
Turns the power on or off.
c C/V
(Skip/Search)
- Skips backward or forward.
- Searches for a section within a file.
- Selects the radio stations.
N
(Play/Pause)
- Starts or pauses playback.
- Selects stereo/mono.
+/-
Adjusts speaker volume.
d
F (Function)
Selects the function and input source.
Specifications
Power Requirements
Refer to the main label on
the unit.
Power Consumption
Refer to the main label on
the unit.
Dimensions (W x H x D)
Approx.
235 mm x 947 mm x 250 mm
Bus Power Supply (USB)
5 V
0
500 mA
Amplier
(Total RMS output power)
60 W RMS
Design and specications are subject to change without
notice.
Replacement of battery
POWER: This unit operates on a mains supply of 200 -
240 V ~, 50 / 60 Hz.
Wiring: This unit is supplied with a BS 1363 approved
main plug. When replacing the fuse, always use a fuse
of the same rating and approved to BS 1362. Never
use this plug with the fuse cover omitted. To obtain
a replacement fuse cover contact your dealer. If the
type of plug supplied is not suitable for the mains
sockets in your home, then the plug should be removed
and a suitable type tted. Please refer to the wiring
instructions below:
Warning: A mains plug removed from the mains lead of
this unit must be destroyed. A mains plug with bared
wires is hazardous if inserted in a mains socket. Do not
connect either wire to the earth pin, marked with the
letter E or with the earth symbol 6 or coloured green
or green and yellow. If any other plug is tted, use same
rating of fuse in the plug.
Important: The wires in this mains lead are coloured in
accordance with the following codes:
- BLUE: NEUTRAL, BROWN: LIVE - As the colours of the
wires in the mains lead of this unit may not correspond
with the coloured marking identifying the terminals in
your plug, proceed as follows: The wire which is coloured
blue must be connected to the terminal which is marked
with the letter N or coloured black. The wire which is
coloured brown must be connected to the terminal
which is marked with the letter L or coloured red.
Additional Information
RK1D-F.ANGAFLK_SIM_ENG_MFL70840204.indd 3-4 2019-05-15 8:34:40