18
OPERATION
OPERATION
Operation Overview
Using the Appliance
Before the first cycle, set the appliance to dry for 5
minutes to warm up the drum. Open the door
between loads the first few times you use the
appliance to allow any odours from the interior of
the appliance to disperse.
Children must be supervised so that they do not
climb inside the drum.
1
Ensure the lint filter and water container are
clean.
• Open the door and ensure the lint filter is
clean. When the filter is full with lint, drying
times will be longer than usual.
• Pull out the water container and empty the
condensed water. When the water container
is full, the appliance may stop during the
cycle.
• In some instance, LED window may display
E
icon to inform you that the water container is
full. If this occurs, empty the water container.
2
Place the clothes into the drum after sorting
and close the door.
• Push the clothes deep into the drum so that
the clothes keeps away from the door seal.
When the clothes get stuck between the
door and seal, they may get damaged while
drying.
• The clothes should be sorted by fabric types
and dryness level.
• All strings and attached belts of clothes
should be well tied and fixed before being
put into the drum.
3
Press the
Power
button to turn the appliance
on.
• Depending on the models, the
Power
button
may light up to indicate that the appliance is
ready for dry.
4
Choose a drying programme by turning the
programme selector knob.
5
Press the
Start/Pause
button to start the
drying programme.
• When you press the button, the appliance
ventilates the inside of the drum for 10
seconds in order to get the appliance ready
for drying operation.
• The appliance washes lint, which builds up onto
the surface of the condenser, automatically
using water that is condensed from the clothes
during operation.
To Next Page
Loading...
Need help?
General
