If you see a red LED on the back of the wireless subwoofer or wireless rear speakers, it means that the
sound bar is not connected to the speakers. If this is the case, connect them in the following order.
Press the Power button on the sound bar to turn it off.
Press the PAIRING (Pairing) button on the back of the disconnected wireless subwoofer or wireless rear s
peakers. Check if each LED blinks green.
– If you still see a red LED on the back of the wireless subwoofer or wireless rear speakers, press and hold the
button on the back of the subwoofer or wireless rear speakers again.
Press the Power button on the sound bar to turn it on.
When the connection is established, you will see a green LED light on the back of the wireless subwoofer
or wireless rear speakers light up in green.
Keep the sound bar, the subwoofer and wireless rear speakers away from the device (ex. wireless router, m
icrowave oven, etc.) over 1 m (3.3 ft) to prevent wireless interference.
● Some speakers may not make sound depend on the input source. Select CINEMA sound mode to listen throu
gh all speakers.
Design and specifications are subject to change without notice.
Google Play is a trademark of Google LLC.
Replacement of Battery
Specification
Power requirements
Refer to the main label.
Power consumption
Refer to the main label.
Sound bar dimensions (W x H x D): Approx. 1443.0 mm x 63.0 mm x 146.0 mm (56.8 inch x 2.5 inch x 5.7 inch)
Wireless rear speakers dimensions (W x H x D): Approx. 130.0 mm x 211.5 mm x 191.2 mm (5.1 inch x 8.3
inch x 7.5 inch)
To Next Page
Loading...
