39
4-7. TROUBLE SHOOTING METHODS ACCORDING TO ERROR MESSAGE
4-7-1. SAFETY CAUTION
4-7- 2. ERROR MODE SUMMERY
• If you press the START/PAUSE button when an error is displayed, any error except will disappear and
the machine will go into the pause status.
• In case of , if the error is not resolved within 20 seconds, or the in case of other errors, if the
error is not resolved within 4 minutes, power will be turned off automatically and the error code
will blink. But in
the case of , power will not be turned off.
• Clutch Motor defectCLUTCH ERROR7
• Door not all the way closed.DOOR OPEN
ERROR
6
• The PRESSURE SENSOR ASSEMBLY is out of
order.
• When water level frequency maintain condition of below 20 kHz
and over 30 kHz
PRESSURE
SENSOR
ERROR
5
• Water is overflowing
(water level frequency is over 20.9kHz).
If FE is displayed, the drain pump will
operate to drain the water automatically.
OVERFLOW
ERROR
4
• Not fully drained within 10 minutes.DRAIN ERROR3
• The load is too small.
• The appliance is tilted.
• Laundry is gathered to one side.
• Non distributable things are put into the drum.
UNBALANCE
ERROR
2
reach the preset water level within 12 minutes
.
WATER INLET
ERROR
1
CAUSESYMPTOMERROR
• Clutch Motor defectCLUTCH ERROR7
• Door not all the way closed.DOOR OPEN
ERROR
6
order.
and over 30 kHz
PRESSURE
SENSOR
ERROR
5
• Water is overflowing
OVERFLOW
ERROR
4
• Not fully drai
ned within 10 minutes.DRAIN ERROR3
UNBALANCE
ERROR
2
• Correct water level is not reached within 8
minutes after water is supplied (below 26.0kHz) or it does not
WATER INLET
ERROR
1
CAUSESYMPTOMERROR
There’s built-in AC 120V and DC power in output terminal of PWB assembly in common. Be careful electric
shock when disconnecting parts while trouble shooting. (Wear Electro Static Discharge gloves when working.)
After cutting off the power when changing PWB assembly, disconnect or assemble.
Be careful static when handling PWB assembly, and use Electro Static Discharge plastic pack
when delivering o
r keeping it.
To Next Page
Loading...
